✨ New: Try our AI‑powered Search (Ctrl + K) — Read more

Testing Network Performance

Prev Next
  • Updated on Apr 15, 2026
  • Published on Dec 15, 2021
Use the traffic generator and monitor to pinpoint devices or network problems, or to measure current throughput, frame delay, and frame delay variation on a specific network segment. This article describes how to set up your Carrier Ethernet network...
  • Updated on Nov 5, 2026
  • Published on Sep 29, 2022
Use a test suite to determine whether a network section or a device conforms to a Service Level Agreement (SLA) or an Ethernet standard. This procedure consists of: Setting up a test suite Running a test suite Viewing a test report Note...
  • Updated on Jan 21, 2026
  • Published on Dec 15, 2021
Configure the unit to automatically upload SAT test reports to a server when a test completes. SAT reporting supports Y.1564 reports. Reports are available in text or XML format. To set up SAT reporting Choose SAT ▶ Reporting . Comp...
  • Updated on Jan 27, 2026
  • Published on Dec 15, 2021
You can include services that have been locally created on the unit in a Y.1564 and RFC-2544 test by enabling an internal loopback on of the unit's UNI ports to redirect the test traffic through traffic policies. Enabling an internal loopback on b...
  • Updated on Oct 23, 2026
  • Published on Oct 23, 2026
Y.1564 is used to perform end-to-end Ethernet service activation tests (SATs). This section describes how to set up Y.1564 in your Metro Ethernet network. The implementation of Y.1564 supports the following test types: Layer 2 two-way testing....
  • Published on Aug 21, 2026
Introduction This document outlines the "Binary Search" algorithm implemented within the Crosswork Assurance hardware sensors and Sensor Control platforms. In standard RFC 2544 testing, the IETF defines a linear search paradigm for most te...