--- title: "Restore Factory Default Settings" slug: "restoring-factory-default-settings-gt" tags: ["reset", "firmware", "restore", "Assurance Sensors", "Assurance Sensor GT", "Assurance Sensor GT-S"] updated: 2026-11-05T16:42:00Z published: 2026-11-05T16:42:00Z canonical: "docs.crossworkassurance.cisco.com/restoring-factory-default-settings-gt" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.crossworkassurance.cisco.com/llms.txt > Use this file to discover all available pages before exploring further. # Restore Factory Default Settings You can reset the unit to its factory default settings either by using the button on the panel of the unit or by using the management Web interface. Each way is described below. **Note:** Only complete a "HARD RESET" when the management Web interface is not responding properly. Contact [Cisco Technical Assistance Center (TAC)](https://mycase.cloudapps.cisco.com/case) if you require assistance. **CAUTION:** Resetting to factory default settings affects current operations. **To reset the unit to factory default settings via the Web interface** 1. Access the page **System ▶ Maintenance ▶ Firmware**. 2. Click the **Factory** default button. 3. Click the **Reboot** button. **To reset the unit to factory default settings from the unit's front panel** 1. Press and hold the **RST** button on the front panel. 2. Keep holding the **RST** button until the LEDs for **Minor**, **Major**, **Critical** and **Power** flash at the same time. 3. Release the **RST** button. **© 2026 Cisco and/or its affiliates. All rights reserved.** For more information about trademarks, please visit: [Cisco trademarks](https://www.cisco.com/c/en/us/about/legal/trademarks.html)[](https://www.cisco.com/c/en/us/about/legal/trademarks.html) For more information about legal terms, please visit: [Cisco legal terms](https://www.cisco.com/c/en/us/about/legal/terms-conditions.html)