--- title: "Manage the NETCONF Agent" slug: "managing-the-netconf-agent-lt" tags: ["NETCONF", "Assurance Sensors", "Assurance Sensor LT-S"] updated: 2024-01-24T22:05:11Z published: 2024-01-24T22:05:11Z canonical: "docs.crossworkassurance.cisco.com/managing-the-netconf-agent-lt" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.crossworkassurance.cisco.com/llms.txt > Use this file to discover all available pages before exploring further. # Managing the NETCONF Agent You can configure a NETCONF agent so users with a NETCONF client can get or edit configuration and get notifications from the unit via the NETCONF protocol. --- ***Note:** Only NETCONF or SNMP (not both) can be enabled at the same time.* --- **To enable the NETCONF agent** 1. Access the page **System ▶Agent ▶NETCONF**. 2. Complete the required fields, then click **Apply**. For more information on specific parameters, refer to the following table. **NETCONF Agent (System ▶Agent ▶NETCONF)** | Parameter | Description | | --- | --- | | Enable Agent | Check box to enable the unit's NETCONF agent. | **© 2026 Cisco and/or its affiliates. All rights reserved.** For more information about trademarks, please visit: [Cisco trademarks](https://www.cisco.com/c/en/us/about/legal/trademarks.html)[](https://www.cisco.com/c/en/us/about/legal/trademarks.html) For more information about legal terms, please visit: [Cisco legal terms](https://www.cisco.com/c/en/us/about/legal/terms-conditions.html)