--- title: "Manage the Loop Detection Diagnostic Tool" slug: "managing-the-loop-detection-diagnostic-tool-gt" tags: ["loop detection", "beacon", "management", "Assurance Sensors", "Assurance Sensor GT", "Assurance Sensor GT-S"] updated: 2024-01-25T19:58:08Z published: 2024-01-25T19:58:08Z canonical: "docs.crossworkassurance.cisco.com/managing-the-loop-detection-diagnostic-tool-gt" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.crossworkassurance.cisco.com/llms.txt > Use this file to discover all available pages before exploring further. # Managing the Loop Detection Diagnostic Tool Use this page to create a manually controlled, customized loop detection beacon, then view its results. ***Note:** The loop detection diagnostic tool does not require an interface to be created in order to send a tunnel-level beacon.* **To configure a customized loop detection beacon** 1. Access the page **Loop Detection ►Diagnostic Tool**. **The Loop Detection Diagnostic Tool** page opens. 2. Use the information in the table below to configure the loop detection beacon, then click **Send**. A loop detection beacon is transmitted from the specified port; Frame is successfully sent appears in the frame at the bottom of the page. If no loop is detected within the period specified timeout value, it will expire. 3. To view the results of the loop detection beacon created in the previous step, click **Show**. The frame at the bottom of the page refreshes with the loop detection beacon’s results. Results similar to the following will appear: Beacon Type : LPDB
Status : Received
Port : PORT-4
Vlan1 Id : 100
Vlan1 Ethertype : T-VLAN
Vlan2 Id : 200
Vlan2 Ethertype : S-VLAN
Vlan3 Id : 300
Vlan3 Ethertype : C-VLAN
Timeout (s) : 3
Round trip time (usec) : 40
For more information on specific parameters, refer to the following table. **Loop Detection Diagnostics (Loop Detection ►Diagnostic Tool)** | Parameter | Description | | --- | --- | | Port | Make a selection from the drop-down list to select the physical port on which to listen for loops. | | Direction | This parameter is not currently used. For future implementation. | | Timeout | Expressed in seconds. Acceptable values range from 3–30. | | VLANn Enable | Check box to enable VLAN for a tunnel-level loop detection beacon. You can select up to three VLAN . | | Ethertype | Make a selection from the drop-down list to select the Ethertype for its associated VLAN ID. Acceptable values are: - **C-VLAN:** 0x8100 - **S-VLAN:** 0x88A8 (or 0x9100) Refer to the global setting for SVLAN Ethertype under **System ▶Configuration ▶Mode** - **T-VLAN:** 0x9100 (or 0x88A8, depending on the value assigned to the S-VLAN Ethertype) | | VLAN ID | The VLAN ID on which the loop detection beacon will be sent. | **© 2026 Cisco and/or its affiliates. All rights reserved.** For more information about trademarks, please visit: [Cisco trademarks](https://www.cisco.com/c/en/us/about/legal/trademarks.html)[](https://www.cisco.com/c/en/us/about/legal/trademarks.html) For more information about legal terms, please visit: [Cisco legal terms](https://www.cisco.com/c/en/us/about/legal/terms-conditions.html)