--- title: "Configure General System Settings" slug: "configuring-general-system-settings-gt" tags: ["settings", "management", "traffic", "S-VLAN", "Assurance Sensors", "Assurance Sensor GT", "Assurance Sensor GT-S"] updated: 2026-07-07T14:04:23Z published: 2025-07-31T18:41:43Z canonical: "docs.crossworkassurance.cisco.com/configuring-general-system-settings-gt" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.crossworkassurance.cisco.com/llms.txt > Use this file to discover all available pages before exploring further. # Configure General System Settings ### Setting the S-VLAN Ethertype The Ethertype value that is associated with the Service VLAN (S-VLAN) is set globally for the unit. The S-VLAN Ethertype options are: - **0x88A8:** Most applications use this value - **0x9100:** A supported legacy value The S-VLAN value is typically left at the default of 0x88A8. If you change the S-VLAN Ethertype value to 0x9100, the T-VLAN Ethertype value will automatically be switched to 0x88A8. All units in a given network that use the S-VLAN Ethertype must have the same assigned Ethertype value. ***Tip:** To avoid issues related to changing the S-VLAN value, consider assigning the appropriate value to the S-VLAN Ethertype before creating system elements that require a defined Ethertype, such as interfaces, filters and RFC-2544.* For more information on specific parameters, refer to the table "General System Settings (**System ▶Configuration ▶Traffic ▶Mode**)". ### Regulating Management Traffic As with other traffic types, it can be useful to regulate management traffic. **To set up the management traffic regulation (MTR)** 1. Access the page **System ▶Configuration ▶Traffic ▶Mode**. 2. Enable the **MTR State** box. 3. Complete the other parameters, then click **Apply**. For more information on specific parameters, refer to the following table. **General System Settings (System ▶Configuration ▶Traffic ▶Mode)** | Parameter | Description | | --- | --- | | S-VLAN Ethertype | This value affects all elements that make use of the S-VLAN Ethertype, such as interfaces and filters. Possible values are: - 0x88A8 - 0x9100 ***Note:** This value is typically left at the default of 0x88A8.* | | T-VLAN Ethertype | This value appears here for your convenience; it is based on the value selected in the S-VLAN Ethertype drop-down list above. | **Management Traffic Regulation (MTR)** | Parameter | Description | | --- | --- | | MTR State | Enable/Disable the regulation of management traffic. | | Rate (Kbps) | The average data rate, expressed in kbps. | | Latency (ms) | The transmit queue size, expressed in milliseconds. | | Burst (bytes) | The maximum burst size, expressed in bytes. | **© 2026 Cisco and/or its affiliates. All rights reserved.** For more information about trademarks, please visit: [Cisco trademarks](https://www.cisco.com/c/en/us/about/legal/trademarks.html)[](https://www.cisco.com/c/en/us/about/legal/trademarks.html) For more information about legal terms, please visit: [Cisco legal terms](https://www.cisco.com/c/en/us/about/legal/terms-conditions.html)